Tenorshare UltData 9.5.0 on Mac

You dropped your iPhone in a puddle, or maybe the screen gave up after a bad fall. Either way, the photos from last summer are sitting on a device that won't turn on. That's the moment you reach for tenorshare ultdata for mac.

The workflow is straightforward. Connect your iPhone, iPad, or iPod touch to the Mac, let UltData scan the device, and pick what you want back. It covers the usual suspects – contacts, messages, photos, notes – but also the stuff you forget about until they're gone: voice memos, Safari history, FaceTime data, even voicemail. Older devices aren't left out either, with support reaching back to the iPhone 4 and the first iPod touch.

You don't need to restore the whole device just to fish out a few reminders. The app lets you preview what it finds before recovering, so you grab only what matters. That's the practical bit I appreciate – no waiting for a full backup restore when all you lost was one note.

UltData runs on macOS 10.10 and later, and the interface is available in ten languages, English included. It's the Mac version of Tenorshare's iPhone recovery tool, built for the times when your data disappears and you'd rather not start over.

Test scan with your device before data loss

Once UltData is in your Applications folder, give it a test run before you actually need it. Plug in your iPhone or iPad and let the app scan even if you haven't lost anything yet. It shows you what a normal recovery session looks like — the scan, the preview list, the categories. That way, when a real accident happens, you already know where everything is and you're not fumbling through menus while your phone sits dead.

Check the three recovery modes while you're at it. One is for direct device scanning, one works from an iTunes backup, and one from an iCloud backup. Knowing which one fits your situation saves time later. If you back up to iCloud regularly, that mode might be your fastest route.

A typical recovery session

Friday night, my iPhone 7 went dark after a drop. No screen, no response. I grabbed the Mac, opened UltData, and connected the phone. The app detected it straight away and offered the three modes — I picked direct device recovery because I hadn't backed up in a week.

The scan took a while. When it finished, the left panel listed every recoverable category. I clicked Messages first, scrolled through the preview, and checked the ones I needed. Then Photos, where I spotted the holiday shots I thought were gone. A few more clicks and I marked them all for recovery.

I hit the Recover button, chose a folder on the desktop, and waited. When it finished, everything was there — the messages, the photos, a couple of voice memos I'd recorded at a gig. Total time from dead phone to recovered data was under half an hour.

Workflow: restoring a single conversation

1. Connect the iPhone and launch UltData. Select the device recovery mode.
2. After the scan, go to Messages in the category list.
3. Scroll through the preview or use the search bar to find the contact you need.
4. Check the specific messages you want, not the whole thread.
5. Click Recover, pick a destination, and export them as a text file or PDF.

That's it. You don't have to restore the entire phone or wait for a full backup download just to get one chat thread back. If you're after a WhatsApp or WeChat conversation, the same steps apply — the app pulls those from the same scan results under the App Data section.

• macOS OS X 10.8 or later
• Intel 64-bit architecture

Kit check at a glance